Registered withGas Safe
24 hours a day, 7 days a week · every London borough
A failed sump pump can flood a basement in hours. We repair and replace pumps, floats and valves, day or night, in every London borough.
A pump that fails during heavy rain will not wait until morning. We answer nights, weekends and bank holidays and treat rising water as an emergency.
We carry common parts such as floats and non-return valves, so many pump faults are sorted on the first visit.
You know what it will cost before we start. The invoice matches what you agreed to.
If a repair is worthwhile we do it. If the pump has had its day, we tell you and explain the options.
Dirty water cleared up, floors protected, and the old pump taken away when we leave.
Most sump pump failures come down to a jammed impeller, a stuck float or a faulty valve. We find which one and fix it, rather than replacing a pump that only needs a small repair.
A pump that stays silent while the water rises. It may be jammed by debris, have a failed motor, or not be getting a signal from its float. We find the cause and tell you whether it is worth repairing.
The pump hums but the water level does not drop. Usually a blocked impeller or strainer, a blocked discharge pipe, or a non-return valve that has failed or stuck shut.
A float that sticks or tangles can leave a pump never starting, or running dry. We free, adjust or replace float switches and check the valves so the pump starts and stops when it should.
Keep safe around electrics. Do not wade through standing water if sockets, extension leads or equipment are in it or near it. Switch off the electricity at the consumer unit only if you can reach it without going through the water.
Move what you can. Lift belongings off the floor and, if it is safe, stop any burst pipe by turning off the stopcock, usually under the kitchen sink.
Then call us on 079 1616 8585. We are available 24 hours a day across London.
If the pump is past repairing, or you want better protection, we fit the replacement properly: the right size for the job, connected so it will keep working when you need it.
A few of the pumps and pump chambers we have repaired and replaced across London.
We look at the problem, tell you what it needs and what it will cost, and only then start work.
| What we look at | Why it changes the cost |
|---|---|
| Repair or replace | A stuck float or a blocked impeller is a quick repair. A pump with a failed motor, or one close to the end of its life, is usually better replaced. |
| Single or twin pumps | A twin pump system with a standby takes longer to work on, and gives you protection if one pump fails. |
| Size and type of pump | Pumps are chosen for the volume of water and the height they must lift it, which affects the cost of a replacement. |
| Access and depth | A shallow pit under a cover is easy to reach. A deep chamber needs more time, lifting equipment and care. |
| Discharge pipework | The length and route of the pipe taking water away, and any valves on it, change how much work is involved. |
One number, every London borough, 24 hours a day. Call 079 1616 8585 or message us on WhatsApp.
Pump not starting, not clearing the water or time for a new one. Call us any time, day or night, anywhere in London.
Call 079 1616 8585Accredited, approved & trusted
